Updated November 19, 2026
Summary: "peptone" is not an ingredient, it is a family
- The per-amino-acid spread is wider than the total spread. Glycine runs from 11 mg/g (yeast extract) to 207.1 mg/g (gelatin-rich bacteriological peptone), an 18.8-fold range. Proline runs 9 to 117.1 mg/g (13.0×). Lysine runs 18 to 60 mg/g (3.3×), methionine 6.5 to 17 mg/g (2.6×), leucine 29.4 to 70 mg/g (2.4×).
- Across five manufacturer-published typical amino acid analyses, total reported amino acids range from 390 to 846 mg per gram of product, a 2.2-fold spread on sums of 15 to 19 reported amino acids (the panels differ by sheet, so read it as indicative), before any lot-to-lot variation is considered: soy peptone (ultrafiltered) 389.8 mg/g, soy peptone (standard) 484.8 mg/g, bacteriological yeast extract 524 mg/g, casein tryptone 781 mg/g, bacteriological (gelatin-rich) peptone 846.3 mg/g. All five are sold to do the same job in a medium.
- Most of what a peptone supplies is not free amino acid, and the free fraction varies by product class. From the three sheets that publish both total and free values: yeast extract's free amino acids are 51.1 mg/g, only 9.8% of its total; the two soy peptones are 183.1 mg/g (37.8%) and 145.0 mg/g (37.2%) free. A cell or microbe that takes up free amino acids sees a different medium than the total numbers suggest.
- Switching between two soy peptones from the same manufacturer changes a defined medium's free amino acid supply by double-digit percentages. At 10 g/L, the standard soy peptone supplies 1,831 mg/L of free amino acids and the ultrafiltered version 1,450 mg/L, a difference of 381 mg/L (21%), including free leucine 290 vs 200 mg/L and free lysine 183 vs 126 mg/L. Same supplier, same nominal ingredient name, different process (ultrafiltration), different medium.
So what: when a fermentation or culture "behaves differently this lot," the first suspect is not the organism. It is the least characterised input in the recipe, and the recipe usually names it with one word.
Why it matters: media teams spec peptones by total nitrogen and a growth test. Neither number sees the amino acid supply, free or total, that the process actually consumes. Profiling an incoming lot, free and total, is AA-1 $150 plus AA-T $230, $380 per lot, plus $30 for extraction of the powder (PREP-1), so $410 against a failed batch.
Profile the lot before the lot profiles your process: free and total amino acids, $380 to $410 per lot.
Introduction
A medium recipe usually names its peptone or yeast extract in a single word, as if that word specified an ingredient. This article asks what that word actually delivers: how much amino acid supply, total and free, does a named product provide per gram, and how far apart are products that are all sold to do the same job in the same medium?
It matters because media teams typically specify these inputs by total nitrogen and a growth test, and neither number can see the amino acid supply the process actually consumes. When a fermentation or culture behaves differently this lot, the least characterised input in the recipe is the first suspect. Profiling an incoming lot, total and free, is a small measurement set against the cost of a failed batch.
The dataset is five manufacturer-published typical amino acid analyses, each read from the sheet itself: a Solabia bacteriological yeast extract, two Nu-Tek soy peptones from the same family in standard and ultrafiltered grades, an Ausamics casein tryptone, and an ITW bacteriological peptone with a gelatin-rich profile. From those sheets this article computes totals, free fractions, and the spread of each individual amino acid across products, then works through what changing nothing but the grade of one soy peptone does to a defined medium. Read the dataset first, then the totals and free fractions, then the per-amino-acid spread. The panels the manufacturers chose to report differ from sheet to sheet, so the totals are sums of what each sheet reports, and the strongest conclusions are drawn per amino acid, where the comparison is like for like.
Total reported amino acids per product
Five products sold to do the same job in a medium, with totals spanning the full range charted.
1. Dataset: five published typical analyses, verified November 5, 2026
| # | Product (manufacturer, sheet) | Source material | Panel reported |
|---|---|---|---|
| P1 | Bacteriological Yeast Extract A120400 (Solabia, technical data sheet v.02/2023) | Yeast autolysate (S. cerevisiae) | Total + free, 17 amino acids (Trp not reported) |
| P2 | Soy Peptone HSP-N, code 1175 (Nu-Tek Biosciences, product spec 2025) | Enzymatically hydrolysed soy | Total + free, 15 amino acids (Cys, Pro, Trp not reported) |
| P3 | Soy Peptone HSP-A10KF, code 1000 (Nu-Tek, product spec; ultrafiltered version of the same family) | Enzymatically hydrolysed soy, ultrafiltered | Total + free, 15 amino acids (Cys, Pro, Trp not reported) |
| P4 | Peptone from Casein / Tryptone AS-1006 (Ausamics, technical data) | Pancreatic digest of casein | Total only, 19 amino acids |
| P5 | Bacteriological Peptone, code 403695 (ITW Reagents, product info) | Enzymatic digest of animal tissue (gelatin-rich profile) | Total only, 18 amino acids, published in g/100 g, converted here to mg/g (×10) |
Scope note (the gap, labelled): the program brief pointed at BD Bionutrients and Thermo peptone/yeast extract sheets. We located the BD Bionutrients Technical Manual and Thermo/Fisher product documents on November 5, 2026, but their publicly accessible pages publish total nitrogen, amino nitrogen, and molecular-weight distributions rather than complete per-amino-acid typical analyses we could extract and verify. Adding BD/Thermo per-amino-acid data is a named next-cycle task; the comparison structure does not depend on which manufacturers fill it.
2. Computed table 1: totals and free fractions
| Product | Total reported amino acids (mg/g) | Free amino acids (mg/g) | Free as % of total |
|---|---|---|---|
| P3 Soy peptone, ultrafiltered | 389.8 (sum of 15) | 145.0 | 37.2% |
| P2 Soy peptone, standard | 484.8 (sum of 15) | 183.1 | 37.8% |
| P1 Yeast extract | 524 (sum of 17) | 51.1 | 9.8% |
| P4 Casein tryptone | 781 (sum of 19) | not published | n/a |
| P5 Bacteriological peptone | 846.3 (sum of 18) | not published | n/a |
Worked example: P2 total = 23.1 (Ala) + 30.3 (Arg) + 64.9 (Asp) + 110.3 (Glu) + 22.4 (Gly) + 15.0 (His) + 25.4 (Ile) + 38.5 (Leu) + 35.9 (Lys) + 7.5 (Met) + 26.2 (Phe) + 27.5 (Ser) + 20.6 (Thr) + 10.8 (Tyr) + 26.4 (Val) = 484.8 mg/g. Limit, stated with the table: the panels differ (15 vs 17 vs 19 amino acids reported; proline and cysteine are missing from the soy sheets, tryptophan from three sheets), so totals are sums of what each manufacturer chose to report, and the true totals of the low-panel products are somewhat higher than shown. The spread conclusions below are drawn per amino acid, where the comparison is like-for-like, precisely because the totals carry this caveat.
Free amino acids as a share of the total
Only the three products that publish both total and free values can be charted here.
3. Computed table 2: per-amino-acid spread across the five products (mg/g, total fraction)
| Amino acid | Minimum | Maximum | Fold range | Which products set the ends |
|---|---|---|---|---|
| Glycine | 11 (P1 yeast extract) | 207.1 (P5 gelatin-rich peptone) | 18.8× | Source material dominates: gelatin is glycine-rich |
| Proline | 9 (P1) | 117.1 (P5) | 13.0× | Same story |
| Lysine | 18 (P1) | 60 (P4 tryptone) | 3.3× | Casein digest ≫ yeast autolysate |
| Methionine | 6.5 (P3) | 17 (P4) | 2.6× | The limiting amino acid in many processes still varies 2.6-fold between products |
| Leucine | 29.4 (P3) | 70 (P4) | 2.4× | Ultrafiltration visibly strips the soy product |
| Glutamic acid | 85.9 (P3) | 167 (P4) | 1.9× | The least variable major amino acid, and still nearly 2× |
Glycine per product: the widest single-amino-acid spread
The same amino acid, supplied at very different levels depending on the source material.
4. Worked example: the same-name switch, and a classic medium
Switch inside one supplier's soy family. Define a medium at 10 g/L soy peptone and change nothing but the grade, standard (P2) to ultrafiltered (P3):
| Free amino acid supply at 10 g/L | P2 standard | P3 ultrafiltered | Difference |
|---|---|---|---|
| All reported free amino acids | 183.1 × 10 = 1,831 mg/L | 145.0 × 10 = 1,450 mg/L | −381 mg/L (−21%) |
| Free leucine | 29.0 × 10 = 290 mg/L | 20.0 × 10 = 200 mg/L | −90 mg/L |
| Free lysine | 18.3 × 10 = 183 mg/L | 12.6 × 10 = 126 mg/L | −57 mg/L |
| Free glutamic acid | 19.1 × 10 = 191 mg/L | 16.5 × 10 = 165 mg/L | −26 mg/L |
| Free methionine | 5.1 × 10 = 51 mg/L | 3.9 × 10 = 39 mg/L | −12 mg/L |
Nothing in the recipe changed. The purchase order still says "soy peptone." The medium's immediately available amino acid supply fell by a fifth.
A classic recipe read through the sheets. A standard LB-style formulation (10 g/L tryptone + 5 g/L yeast extract) carries, from P4 and P1 typicals, a total leucine supply of 70 × 10 + 38 × 5 = 890 mg/L, of which the yeast extract's free leucine is only 4.6 × 5 = 23 mg/L; the tryptone sheet publishes no free fraction at all, so the free leucine of the complete medium cannot be computed from published data. That un-computability is the article's point in miniature: the most-used medium in biology has no published free amino acid budget.
5. Perspectives
- Process: treat peptone grade changes, including "same product, new process step" changes like ultrafiltration, as medium changes. Re-validate; do not assume.
- QC: an incoming-lot spec that can actually catch this is a total + free amino acid profile with acceptance bands on 3–4 process-critical amino acids (methionine and leucine are the usual suspects), not total nitrogen alone.
- Procurement: a cheaper peptone is the same product only if the profile is. Compare cost per gram of the amino acids your process is limited by, not cost per kilogram of powder.
- Analytical: total and free profiles answer different questions. Total predicts the nutrient ceiling; free predicts what is available before proteolysis. Hydrolysate products blur the two, which is why both are measured.
Profile your own lots
AA-1 ($150) gives the free amino acid supply, 19 amino acids plus ammonia, in µM and mg/L. AA-T ($230, hydrolysis included) gives the total, 16 amino acids in g/100 g, not tryptophan, and not cysteine unless AA-3 is added. Peptones and yeast extracts are powders that need extraction, so add PREP-1 at +$30 per sample. Free plus total on one lot is $410. For the total you can also compare against the manufacturer sheet; the sheet is a typical value and your lot is a specific one. Five lots of one product is 5 x $410 = $2,050. Overnight turnaround available, with expedited service on request. Standard results in 3 to 5 business days from receipt.
Order samples See an example report
AA-1 on each incoming peptone or yeast extract lot is $150 per sample, $125 at 15 or more samples a month, and $99 at 30 or more a month on a 6-month plan (PLAN-1). A Lab Pack 10 is 10 samples prepaid for $1,250. Powders that simply dissolve in water carry no preparation charge; if a lot needs weighing and extraction, PREP-1 adds $30. When the question is total composition, AA-T is $230 per sample, hydrolysis included.
Methods & Sources
- Manufacturer sheets (accessed November 5, 2026): Solabia Bacteriological Yeast Extract A120400 technical data sheet (v.02/2023): total and free amino acid distribution in mg/g; stated on the sheet to be typical analyses, not specifications. Nu-Tek Biosciences Soy Peptone HSP-N (1175_HSP-N_ProductSpec, 2025) and Soy Peptone HSP-A10KF (1000 product spec): typical amino acid profile, total and free, mg/g. Ausamics Peptone from Casein (Tryptone) AS-1006 technical data: amino acid composition mg/g. ITW Reagents Peptone, Bacteriological (403695) product info: amino acids in g/100 g, converted ×10 to mg/g.
- Formulas: totals = sum of reported amino acids per sheet; free fraction = free sum ÷ total sum; medium supply = mg/g × g/L; fold range = max ÷ min across products reporting that amino acid.
- Limitations: typical analyses are manufacturers' representative values, not lot certificates and not specifications; panels differ between sheets (see §2); two products publish no free fraction; no product was purchased or tested for this article; lot-to-lot variation within a product is not published by any of the five manufacturers and is therefore not estimated here. That last gap is the one a buyer's own lot profiling exists to close.