HPLC testing laboratory · Davis, CaliforniaPublished pricesBook onlineinfo@openchemworks.com
Insights

Free vs total amino acids: what a label claim actually needs, per matrix

Published October 30, 2026Updated November 19, 20266 min readOpenChemWorks Laboratory
Short answer

A claim about amino acids that are already free in the product needs a free measurement; a claim about the amino acids bound in a protein needs a total measurement (acid hydrolysis first); a claim about how far a protein has been broken down needs both, because the answer is the difference between them.

The one-sentence rule

A claim about amino acids that are already free in the product needs a free measurement; a claim about the amino acids bound in a protein needs a total measurement (acid hydrolysis first); a claim about how far a protein has been broken down needs both, because the answer is the difference between them.

Ordering the wrong one does not give a weaker answer, it gives an answer to a different question. A free panel on a whey powder reads near zero for most amino acids, not because the powder is empty but because its amino acids are bound. A total panel on a drink spiked with free glycine counts that glycine as if it belonged to the protein.

Companion, not a duplicate: the methods page Free vs Total Amino Acids: Which You Need explains the two preparations in general. This note is the label-claim companion: it works claim by claim, matrix by matrix.

Per matrix: what each claim needs

MatrixTypical label claimMeasurement neededWhy
Ready-to-drink beverage / drink mix with free-form amino acids added, no intact protein"5 g BCAAs per bottle", "EAAs per serving"Free (AA-1)The claimed amino acids were added as free amino acids and sit in solution unbound; a free panel measures each one individually, in mg per serving, against the label
Beverage or shake with intact protein (dairy, soy, pea)Grams of protein; amino acid composition; "complete protein"Total (AA-T)Nearly all of the amino acids are bound in the intact protein. Only hydrolysis releases them for measurement; a free panel would miss the product itself
Supplement powder, intact protein (whey, pea, collagen)Protein content per scoop; per-amino-acid composition; essential amino acid totalTotal (AA-T)Same reason: the claim is about the protein's composition, which is a bound pool. Report per amino acid in g/100 g and mol%, not as a single nitrogen-derived number
Supplement powder or capsules, free-form amino acids (BCAA/EAA blends)"5 g BCAAs, 2:1:1" per servingFree (AA-1)Nothing is bound; there is nothing to hydrolyze. The free panel also verifies the stated ratio, which a total figure alone cannot check (see the BCAA companion note)
Protein hydrolysate (powder or drink)"Hydrolyzed", degree of breakdown, fast-absorption framingBoth (AA-1 + AA-T)Free shows what has been fully released; total shows the whole composition. The bound share per amino acid is (total − free) ÷ total, neither measurement alone contains it
Gummies and chews carrying free-form amino acidsmg of named amino acids per gummyFree (AA-1), with the prep statedThe claimed amino acids are free-form, but the matrix is not a drink: the sample is dissolved whole before analysis, and the report should say so

Three traps this prevents

1. The nitrogen shortcut. Grams of protein on a Nutrition Facts panel may be calculated from total nitrogen (nitrogen × 6.25, per 21 CFR 101.9). That is a nitrogen measurement, not an amino acid measurement: cheap free amino acids added to a powder raise the nitrogen number exactly as intact protein does. A per-amino-acid profile, free, total, or the pair, is what separates "protein by arithmetic" from protein by composition.

2. Reading a total number as a free claim (and the reverse). If a drink claims a specific amount of free leucine, a total result cannot support it: the total folds in any leucine still bound in peptides. If a powder claims a full essential-amino-acid composition, a free result cannot support it: most of those amino acids never appear in the free pool. Match the preparation to the claim's own words.

3. Forgetting what hydrolysis changes. A total result is not the free result "plus more of everything". Under the standard conditions (6 N HCl, 110 °C, 24 hours), tryptophan is destroyed and cysteine/cystine is not reported, so AA-T reports 16 amino acids; asparagine and glutamine are converted, so aspartate and glutamate are reported as the combined Asx and Glx; serine and threonine are partly lost, methionine can partly oxidize, and valine and isoleucine bonds hydrolyze slowly, so 24 hours can under-recover them. A label claim that turns on tryptophan, or on glutamine as glutamine, cannot be settled by a total panel at all, it needs the free panel (where both are reported as themselves) or a separate workup. State this before ordering, not after the report lands.

Worked example (illustrative, not laboratory data)

A pea-protein drink mix claims "10 g protein per serving, complete amino acid profile".

  • Free panel ordered alone: most amino acids read at trace levels. Wrong conclusion available: "the product is empty". Correct reading: the test skipped the protein.
  • Total panel ordered: per-amino-acid composition in g/100 g, Asx/Glx combined, no tryptophan figure. This supports the composition claim for the 16 reported amino acids. Two gaps matter for a pea protein. Tryptophan is destroyed in hydrolysis and is not reported. The sulfur amino acids are usually the limiting group in pea protein, and cysteine is not reported in AA-T while methionine is only partly recovered. The report must flag all three.
  • What the brand actually needed: the total panel for composition, plus an explicit plan for the tryptophan and sulfur amino acid gaps, agreed before sampling. Cysteine can be added through an AA-3 workup on request; tryptophan after acid hydrolysis is not offered here.

What to send, and what the report must show

  • Name the claim first (for BCAA and drink claims see verifying BCAA label claims and protein drink verification). Send the exact front-panel wording with the sample. The lab's job is to test that sentence, and the free/total choice follows from it.
  • Per-amino-acid numbers, not a single total. mg per serving (free claims) or g/100 g and mol% (total composition), each amino acid next to the label figure it is being checked against.
  • The preparation, stated. Free: protein removed, no hydrolysis. Total: 6 N HCl, 110 °C, 24 hours, with the hydrolysis artifacts above carried into the report's notes.
  • The chromatogram and the run's QC summary, with calibration against reference standards, the evidence behind the numbers, as on every OpenChemWorks report.

Pricing: free amino acids (AA-1, 19 amino acids plus ammonia) $150 per sample; total amino acids (AA-T, hydrolysis included) $230 per sample; free and total on the same sample $380, plus $30 per sample if a powder needs extraction (PREP-1); order minimum $150. See an example report and order samples.

Scope

  • This note describes which measurement a claim needs. Results support product and label-claim decisions. Tell us what your results are for and we will confirm the fit before you ship.
  • Amino acid analysis does not detect non-amino-acid ingredients (creatine, caffeine and sweeteners each need their own assay), and no amino acid panel by itself establishes a protein-quality score, digestibility is a separate input.
  • One sample is one lot at one moment. A label claim is a per-lot promise; the per-lot verification plan in the BCAA companion note applies here unchanged.
  • The extended panel compounds are on-request add-ons, not part of the standard panels named above. Taurine is not in the standard 19 amino acid AA-1 panel; AA-1 (Taurine) adds it to the full analysis at $150 per sample.

OpenChemWorks Laboratory · Reviewed by the OpenChemWorks laboratory · Published October 30, 2026 · Updated November 19, 2026

Get the next one in your inbox

One email per post, the science, no spam, no list-selling. Unsubscribe anytime.

Ready to send samples?

Overnight turnaround available, with expedited service on request.
We use AQC derivatization with HPLC and dual UV and fluorescence detection. New clients can start with a $250 five-sample pilot, credited in full toward a first order of 20 or more samples within 90 days.